Nets with Multiple Names

Parent category: Violations Associated with Nets

Default report mode:

Summary

This violation occurs when a net in the design has been detected to have multiple names associated with it.

Notification

If compiler errors and warnings are enabled for display on the schematic (enabled on the Schematic - Compiler page of the Preferences dialog) an offending object will display a colored squiggle beneath it. A notification is also displayed in the Messages panel in the following format:

Nets <Identifier> has multiple names (<NameList>),

where:

Identifier represents the type of connection and the name of the net. The connection can be one of the following:

• Wire - where the identifier will appear in the format Wire NetName (e.g. Wire DTSA)
• Bus - where the identifier will appear in the format Bus Slice NetName (e.g. Bus Slice A[0..7])
• Bus Element - where the identifier will appear in the format Element[n]: NetPrefix (e.g. Element[0]: A)

NameList is a comma-separated list of all names found associated with the offending net. These names can come from attached net labels, sheet entries, power ports and offsheet connectors.

Recommendation for Resolution

This violation can be resolved by ensuring that the names of all net identifiers associated with a particular net are the same. However, should you wish to freely use multiple names with nets in your design, and prevent related violation messages appearing in the Messages panel, simply set the Report Mode for this violation type to No Report, on the Error Reporting tab of the Options for Project dialog (Project | Content | ).